ModelCL-MK4Dimension145*80*11mmCeramic discDia. 20mmWire0.5mWater level sensor H26mmWork voltageDC 36VCurrent4.8-4.5APower 90WHousing material 304SSCeramic disc1.7MHZ N.W. (KG)0.6Warranty5000 hours
Use Ultrasonic Mist Maker
1 when the mist maker works, please do not put your hand in the atomizer spray chamber above, in order to prevent the ultrasonic injury.
2 Mist maker must be in the water to work properly, please before use and put it into the water and then connect the power supply, and ensure that the atomizing sheet surface in water state, so as to avoid damage to the atomizer.
3 when to stop using the mist maker before disconnecting the power supply, and then removed from the water atomizer.
4 Together with mist maker, please use the output power of greater than 300W, output voltage of DCV48 power supply.
5 Mist maker is better to work with fan
6 During the installation process please not to damage the water level sensor. so as to avoid the water level switch failure caused by uncontrolled atomizer.
Application of Mist Maker
1.Waterscape pool manufacturing fog
2.Spinning humidification
3.Tobacco humidification
4.Mushroom humidification
5.Greenhouse flowers humidification
6.Printed Electronics humidification
Warm Tips
a. Please use clean water instead of dirty water, and the water can not be very hard. Less calcium.
b. Draining the water in the tank if you do not use it for long time.
c. Clean the mist module often with soft brush and clean water.
d. If the fog is decreasing, we suggest you replace the mist modules.